Recommended Edits for Section 1.8 of 03-107r1

To:	J3

From:	Craig Dedo

Date:	April 2, 2003

Subject:	Recommended Edits for Section 1.8 of 03-107r1

JOR reviewed the changes recommended in section 1.8 of paper 03-107r1. JOR recommends making all of the indicated changes, except for the two that are noted.

1.8 Changes recommended for Section 9

Most of the following changes were proposed in paper 02-283r1 at J3 meeting 163.17

[192:6]	Change "re-applied " to "reapplied ".

[194:25]	Do not change "ID=specifier" to "identifier (9.5.1.8)".

[202:28]	Change "specifer " to "specifier ".

[203:16-17]	Delete "or dummy procedure pointer". Insert "to "between "or" and "a" at [203:17].

[211:30-31]	Delete sentence "The value ... specified unit."

[214:16]	Insert "=" after "IOLENGTH ".

[190:14-15]	Replace the sentence "This specifier may ... access." with the following sentence:"This specifier may appear in a data transfer statement only if the statement specifies a unit connected for stream access."

[207:11-12]	Delete the word starting with "or" and replace with, "or a processor-dependent negative value if the flush operation is not supported for the unit specified ".

[207:12+]	Delete Note 9.57.

[188:8+]	Do not make the following edit.

Insert:

C929a (R914)	If default-char-expr is an initialization expression (7.1.7),the leading part of its value shall be a valid format-specification.

References

02-007r3, Fortran 2000 Committee Draft

03-107r1, Comments on Committee Draft for 1539-1

[End of J3 / 03-178]