To: J3 J3/01-387 From: Group C Date: December 3, 2001 Subject: Typos and LaTeX conversion bugs, Sections 0-4 Page and line numbers from 007R4 (LaTeX version) [xii:4] "techical" -> "technical" [13:23] "in and . shows" -> "in Table 2.1 and Table 2.2. Table 2.1 shows" [13:38] "shows" -> "Table 2.2 shows" [20:32-33] prevent "nth" from being split across lines [23:29] " 1 2 " -> "0 1 2 " [35:bottom - 36:top] Only the part of Note 4.9 referring to the arithmetic IF should be in small font. [39:Note 4.14+2] The sets of double apostrophes should be quote marks instead. [42:19] "?" -> ">" [43:22] "?" -> ">" [46:13] "(see )." -> (see Note 4.24)." [46:14] "(see )." -> (see Note 4.23)." [46:Note 4.23+10] The sets of double apostrophes should be quote marks instead. [47:Note 4.25+9] The sets of double apostrophes should be quote marks instead. [47:Note 4.26+5] The comment should be shifted to the right to line up with the comments above and below. [53:Note 4.46+1] close gap in "type-name s" [53:Note 4.46+2] close gap in "derived-type-stmt s" [55:Note 4.52+1] "in ." -> "in Note 4.31." [57:Note 4.54+3] "in :" -> "in Note 4.51:" [57:Note 4.55+1] "in :" -> "in Note 4.20:" [58:Note 4.56+1] "in " -> "in Note 4.21 " [58:Note 4.57+3] "in" -> "in Note 4.29" [58:Note 4.57+6,7] The sets of double apostrophes should be quote marks instead. [60:13] remove the line break after "An" [62:4] "s(/" -> "(/" [63:Note 4.69+1] "in ," -> "in Note 4.20," [63:Note 4.70+1] "in ," -> "in Note 4.26,"